…And makes the connection incredibly delicate. All of the mechanical stress from any flexing of the wire will be concentrated at the point where the solder stopped wicking up the wire. If you are worried about corrosion ruining the conductivity of the crimp, then apply some dielectric grease or similar to seal out moisture etc.

“Writing an application is difficult, and it should be. It’s a new industry and you want only the best actors in the space or it can leave a black eye on the whole industry. It makes sense that it’s as competitive and complex as it is.

Abstract: A data center interconnection (DCI) network may comprise a data center controller (DCC) managing a plurality of data centers (DCs) interconnected by a provider network managed by a network provider controller (NPC). The provider network may be an OpenFlow based software defined networking (SDN) transport network. The DCC may initiate a virtual network service (VNS) negotiation with the NPC to connect the DCs and may specify a network abstraction granularity level. The NPC may respond by computing paths through the provider network accordingly and providing the DCC with one or more virtual networks (VNs). The DCC may compute virtual paths through the VNs and send virtual network element (VNE) connection setup commands to the DCC. The DCC may convert the VNE connection setup commands into network element (NE) commands to setup connections in NEs of the provider network. The DCC and the NPC may perform fault monitoring, detection, and recovery.

“I still prefer crimp/solder/shrink tube methods though. Had more than a few crimped wires fail in a plant with tons of connections.” Hate to tell you but your crimps apparently weren’t good. Soldering the crimps would just hide that temporarily.

We have agreed to pay the expenses incurred by the selling stockholder in connection with this offering, including the underwriting discounts and commissions otherwise payable by it to the underwriters for this offering.

Increased regulation associated with climate change and greenhouse gas emissions could impose significant costs and obligations.

Inventor(s): James D. Lilly (Silver Spring, MD), James F. Corum (Morgantown, WV), Joseph F. Pinzone (Cornelius, NC), Kenneth L. Corum (Plymouth, NH) Assignee(s): CPG TECHNOLOGIES, LLC (Red Oak, TX) Law Firm: Tucker Ellis LLP (4 non-local offices) Application No., Date, Speed: 14849208 on 09/09/2015 (979 days app to issue)

Thanks bechdan for info,bianchi is 2017 model it’s fully specced with eps chorus,carbon bars seat post,mavic 50mm carbon cosmic wheels,so really is…

The obvious reason for these varying opinions is that different products require different packaging—and there is a glut of both. Selecting packaging that highlights your brand and protects your product’s integrity is difficult enough. Toss in the fact that all those different containers, bags, jars and tubes must still comply with state regulations, and suddenly you’ve found yourself in a packaging black hole without a sense of direction.

Shortly after 8, Varsano pressed some buttons in an app on his phone to raise the shades, and the showroom’s gray-and-blue interior flooded with rare London sun, mottled with umber from a hurricane bound for Ireland. Varsano’s visitors tended in the past to show up whenever and however they felt like it, so Varsano was anxious that initial business would be slow. The storefront’s start-up costs had been extremely high. He occasionally mentioned to people that for the capital he sank into the store, he could have his own plane.

He holds over 250 other patents as well. He was born in Prince Edward County, Virginia in 1931. James would later graduate from Temple University in 1957 with a degree in Physics. He then began a lifetime career at Bell Labs as full-time acoustical scientist.

Rollings had a leg-long list of credentials as a musician, arranger and producer. For Popper, one notch in particular—sitting behind the board for Willie Nelson’s Grammy-winning Summertime: Willie Nelson Sings Gershwin—was more than enough. “That’s all I needed to hear because I’m a very big Willie fan.”